AC Installation & Replacement in Texas
Replacing a central AC is the most consequential HVAC purchase most homeowners make, and the equipment brand matters less than most people think. What decides comfort and bills for the next 15+ years is sizing (Manual J load calculation, not rule-of-thumb tonnage), ductwork condition, and installation quality — refrigerant charge, airflow, and line-set practices that most homeowners never see.
Texas cooling loads are brutal — long summers in the triple digits across Dallas, Houston, and San Antonio keep air conditioners running for months, and Gulf humidity forces systems to dehumidify as well as cool. The flip side is winter: deep-freeze events burst pipes and kill heat pumps statewide, so cold-climate performance now matters in bids. Hail season also chews up condenser coils and outdoor units across North Texas.
The short answer for Texas
Full central air conditioner replacement — proper sizing, new refrigerant lines, and commissioning done right. In Texas, the deciding factor is extreme heat: Sizing by Manual J matters most where cooling dominates — oversized systems short-cycle, leaving homes cold but clammy because they never run long enough to dehumidify.
How Texas’s climate affects this choice
Extreme heat: Sizing by Manual J matters most where cooling dominates — oversized systems short-cycle, leaving homes cold but clammy because they never run long enough to dehumidify.
Humidity: In humid climates, dehumidification capacity decides comfort as much as tonnage — two-stage and variable-speed equipment earns its premium here.
What the job involves
- Perform a Manual J load calculation — measuring your home, insulation, windows, and orientation — instead of sizing by square footage
- Evaluate the existing ductwork for leaks, sizing, and insulation before quoting equipment
- Remove the old condenser, air handler/coil, and refrigerant per EPA recovery rules
- Set the new condenser on a level pad with proper clearances, run or replace the line set
- Evacuate the lines to a deep vacuum, charge by weight and then fine-tune with superheat/subcooling
- Commission the system: verify airflow, static pressure, temperature split, and thermostat operation
Do this first
- Get at least three quotes — and compare the load calculations and scope, not just the bottom line.
- Ask each bidder: 'What size did your Manual J give, and can I see it?' Anyone sizing by square footage alone is guessing.
- Ask what's included: line set replacement, pad, disconnect, thermostat, permits, and old-equipment disposal.
- Check the contractor's license with your state board yourself and confirm they pull a permit where required.
Licensing note for Texas
Texas requires an Air Conditioning and Refrigeration Contractor license (TACL) through the Texas Department of Licensing and Regulation. Confirm the license is current before hiring.
Licensing rules change — verify current requirements with your state board before authorizing work.
AC Installation & Replacement in Texas: FAQ
The size your home's heat gain requires — determined by a Manual J load calculation, not by square footage or by matching the old unit's size. Oversized systems short-cycle: they cool fast but never run long enough to dehumidify, leaving you cold and clammy with higher bills.
A straightforward like-for-like replacement typically takes a day. Jobs with ductwork modifications, electrical upgrades, or difficult access can run two to three days. Ask for the schedule in writing before work starts.
Often yes, if both are old. A new high-efficiency condenser paired with a 20-year-old air handler won't deliver its rated efficiency, and you'll pay for a second installation visit later. If the indoor unit is relatively new and compatible, keeping it can make sense — ask for the efficiency math both ways.
Call or request service online and a local Texas contractor will schedule a free on-site estimate. Only an in-person inspection produces a real number — beware anyone who prices the job without measuring.
Texas requires an Air Conditioning and Refrigeration Contractor license (TACL) through the Texas Department of Licensing and Regulation. Confirm the license is current before hiring.